Bookmark and Share

You have not viewed any products recently.




Walnut Hollow® Products:

  • Creative Versa-Tool® #38283
  • Recipe Box #1728OP
Other Supplies:
  • Alphabet stencil
  • Pencil
  • Metal ruler
  • Pliers
  • Tape
  • Paper towel
  • Ceramic dish




  1. After reading all manufacturers instructions found inside the Creative Versa-Tool, attach Flow Point on Tool. Secure Tool Stand to work surface with tape. Place Tool on Stand. Plug into electric outlet, turn Versa-Temp control dial to the Red Zone, and heat for 4-5 minutes.

  2. Meanwhile, use the ruler to find the center of the Plaque. Tape stencil in place to center tile design. Use pencil to trace stencil design onto wood surface. Trace corner elements with pencil also.

  3. Use Flow Point to wood burn each stencil design. Woodburn dots by holding Creative Versa-Tool perpendicular to the wood surface, touching the surface, then lifting the Point off the surface. You can make smaller or larger dots by touching lightly or a little stronger. Once all elements are wood burned, use pliers to remove Flow Point and drop it into the ceramic dish.

  4. Use pliers to attach the Shading Point. After wood burning all edges of the Plaque, turn Versa-Temp control dial to “O” – off.

  5. Use eraser to remove any remaining pencil lines.

  6. Use foam brush to seal entire Plaque. Let dry.

  7. Lightly sand entire surface with fine sandpaper.

  8. For a protective finish, spray Plaque with 2-3 coats of spray varnish.


Designed by Chris Wallace for Walnut Hollow®