Bookmark and Share

You have not viewed any products recently.

 
 

CRAZY QUILT CLASSIC BOX

Quilt-Pattern-Classic-Box-ProjectWalnut Hollow® Products:

  • #3219 Classic Box 
  • #5570 Creative Woodburner® Value Pen 
  • #1095 Graphite Transfer Paper 

Other Supplies:

  • Colored Pencils
  • Quilt Pattern
  • metal ruler
  • paper towel
  • pen or stylus,
  • sandpaper
  • spray varnish
  • tape

 

Instructions:

  1. To prepare box for woodburning, use sandpaper to lightly sand entire box.  Remove dust with paper towel.

  2. To create the quilt design, use your imagination and create your own design, get ideas from fabrics or papers, or use the attached pattern.  To transfer a pattern, place pattern on box.  Tape in place.  Slide graphite paper under pattern, (carbon side down).  Use a pen or stylus to trace pattern.  When complete, remove pattern and graphite paper.

  3. Before using hot tool, read through and follow all safety precautions on packaging.  Practice on a scrap of wood to determine which point will work best for the individual designs.  Do not press too hard when woodburning.  Use a light touch and just let the tool glide over the wood.  The Shading Point is used for the leaf designs and for the dark shading around the rim of the lid and also the band across the bottom of the box.  The Universal Point works well for the straight lines.  The Cone Point will easily create the curved lines of the flowers and the swirls.  The Flow Point is used for making dots.  For larger dots, just press a little harder.  To start, attach the Universal Point to the tool.  Tighten with pliers.  Secure stand to hard surface with tape.  Place tool on stand.  Plug into electric outlet and heat for 4-5 minutes.

  4. Use the Universal Point to create the sections of the pattern.  Place a metal ruler on the long straight lines.  Pull the Universal Point along the ruler.  Use the Universal Point and metal ruler for any other straight lines in the pattern.  When complete, unplug tool and let cool. 

  5. Attach a new point to tool and follow directions for use as noted above.  If points are removed before they are completely cool, always use pliers and drop points in a glass or metal container to protect the work surface. Continue using whichever point is appropriate.  When complete, unplug tool and let cool.

  6. Use Colored Pencils to add color to the designs.

  7. Apply 2-3 coats of spray varnish for a protective finish.

Designed by Chris Wallace for Walnut Hollow®