
Walnut Hollow® Products:
-
#38383 Creative Versa Tool®
-
#27670 Basswood Country Round®
-
#23855 ¾” 3 Pc. Clock Kit
Other Supplies:
-
Oil Pencils
-
Color laser image of your choice, approx. 8” x 6”
-
One AA battery
-
Blue painters tape
-
Drill
-
Fine sandpapeR
-
Spray varnish
Instructions:
Note: Image needs to be from a laser copy machine for transfer to be successful.
-
Read all instructions and safety information on packaging.
-
Drill a 3/8” hole in the center of Basswood Country Round®.
-
Use masking tape to secure the Pen holder to the work surface. Attach and tighten with pliers the Point you are going to use on the Creative Versa-Tool™. For this project, the Transfer Point will be used.
-
Plug the cord into the electrical outlet to heat. It usually takes 3-4 minutes for the Pen to heat. Remember when changing Points, they are hot, and pliers are needed to attach and remove Points from the Creative Versa-Tool™.
-
Tape laser image face down onto Basswood Country Round® with blue painter’s tape.
-
Using a circular motion, rub the Transfer Point against the back of the copied image.
-
It will take approximately 15-20 minutes to transfer the design from the copy to the Basswood Country Round®.
-
Use Oil Pencils to add color and define image.
-
For a protective finish, spray 2-3 coats of varnish
-
Use fine sandpaper to distress clock numbers.
-
Adhere clock numbers to the front of the clock.
-
Follow package instructions to install clock movement.
-
Insert AA battery. Set time. Enjoy!
Designed by Rebekah Meier for Walnut Hollow®
WALNUT HOLLOW PRODUCTS USED IN THIS PROJECT: