Bookmark and Share

You have not viewed any products recently.

 
 

LIVE, LOVE, LAUGH

LIVE_LOVE_LAUGH

Walnut Hollow® Products:

  • #38931 Shadow Panel, 8 x 10” Rectangle
  • # 38283 Creative Versa-Tool®
  • # 26162 HotStamps Alphabet Set

Other Supplies: 

  • Birds & Berries Stencil (or any stencil)
  • Ceramic dish or mug
  • Fine Sandpaper
  • Masking tape
  • Pencil
  • Pliers
  • Ruler
  • Varnish (spray or brush-on)

 


Instructions:

  1. After reading all manufacturer’s instructions found inside the Creative Versa-Tool, use pliers to attach Flow Point on Tool. Secure Tool Stand to work surface with tape. Place Tool on Stand. Plug into electric outlet, turn Versa-Temp control dial to Red Zone and heat for 4-5 minutes.

  2. Position stencil on Shadow Panel, leaving room to personalize under branch. Tape in place. Use pencil to trace stencil design onto Panel.

  3. Use Flow Point to wood burn branches and berries. Outline bird, legs, feet and eye. Use pliers to remove Flow Point, dropping it into the ceramic dish.

  4. Attach Shading Point with pliers. Wood burn very lightly inside bird with the very flat portion of the Point. Use pliers to remove Shading Point, dropping it into the ceramic dish.

  5. Attach Circle Hot Stamp with pliers. Wood burn entire edge of Panel with half of the Stamp on the top edges and the full Stamp on the side edges. Use pliers to remove Circle Hot Stamp, dropping it into the ceramic dish.

  6. To personalize, attach appropriate letter from Alphabet Set with pliers. Place Tool on Stand.

  7. Use ruler and pencil to draw line under branch for personalization. Carefully burn each letter, removing and attaching each letter with pliers.

  8. Erase any remaining pencil lines.

  9. For a protective finish, apply 2-3 coats of varnish.

 

Designed by Chris Wallace for Walnut Hollow®

 

WALNUT HOLLOW PRODUCTS USED IN THIS PROJECT: