Bookmark and Share

You have not viewed any products recently.




Walnut Hollow® Products:

  • Dog Bone Signboard 
  • Creative Versa-Tool™ 
  • Laser Cut Wooden Alphabet 

Other Supplies:

  • Drill
  • Power Screwdriver
  • Paint
  • 12 Screws (shorter than ¾”)
  • 15” Chain Hanger              
  • Decorative Stamp or stencil
  • Craft glue
  • Sandpaper
  • Flat brush
  • Paper towel
  • Pliers
  • Spray varnish
  • Tape



  1. To prepare signboard for painting, sand the entire surface with fine sandpaper.  Wipe off dust with paper towel.

  2. Use flat brush to apply paint to entire surface.  Let dry.  Apply second coat if needed.  When paint is thoroughly dry, sand over painted surface to create an aged look. 

  3. Use decorative stamp with coordinating paint to create design on front of Signboard.  Let dry. (If using stencil, apply paint with stencil brush.) 

  4. Use craft glue to attach letters to front of signboard. 

  5. Attach Mini Flow Point to Creative Versa-Tool™ by screwing Point into tip of tool.  Tighten with pliers.  Secure stand to hard surface with tape.  Place tool on stand.  Plug into electric outlet.  Turn switch “On”.  Let heat for 4-5 minutes.  Practice on scrap of wood to get a feel for the tool before beginning project.  Create small dots by lightly pressing Mini Flow Point in a random pattern on each letter.  Turn switch “Off”.  Unplug tool.  Apply 2-3 coats of spray varnish.

  6. Referring to photo for placement, use drill to drill 12 holes where screws will be inserted.  Match drill bit to size of screw.  Be careful not to drill through back of signboard.

  7. Use screwdriver to insert screws into pre-drilled holes.  Attach chain hanger to first and last screws on upper row of screws.


Designed by Erin Bykowski for Walnut Hollow®