|
Instructions:
1. Trace around outside of Tag with a pencil, onto the black cardstock. Cut out shape and adhere to Tag using craft glue.
2. With a decorative edge scissors, cut out a 3 3/4" x 3/4" rectangle from an orange piece of scrap paper.
3. Attach the HotMarks™ Everyday Series 1 pumpkin stamp to the Creative HotMarks™ and tighten with pliers. Plug into electrical outlet, turn switch "on" and allow to heat. Stamp five pumpkins onto the cut piece of orange paper (as shown above). With glue, attach to the bottom of the tag.
4. Place skeleton and witch accessories on tag as desired and secure with glue.
5. Using a computer, print out the words "Trick or Treat" in a fun font. Be sure the text is white with a black background before you print (do not attempt to print onto a black piece of paper). Cut out each word, place on tag, and secure with glue. You can also use white alphabet stickers instead of a computer print out to spell out "Trick or Treat".
6. Embellish Tag by tying a ribbon at the top, be sure to leave slack on each end. On Thread wooden beads and orange beads in a pattern onto the ribbon ends; secure beads with a knot. Glue 2 black buttons to bottom of the tag as shown above.
Note: Before you begin, the Creative HotMarks™ tool works best when used with the Walnut Hollow™ Tempered Glass Mat.
It will ensure that your work area will not be damaged from heat. Use masking tape to secure the Pen holder to the work surface.
Attach and tighten with pliers the Point you are going to use on the Creative HotMarks™. Plug Pen in and turn switch "on".
It usually takes 3-4 minutes for the Pen to heat. Remember when changing Points, they are hot and need pliers to remove or attach to the Creative HotMarks™.
After removing the hot Points, place them in the molded tray of the Tempered Glass Mat to cool.
|
