|
Instructions:
1. Attach the letter T to Creative HotMarksT. Tighten with pliers. Use tape to secure stand to hard surface. Place Creative HotMarksT on stand. Plug into electric outlet and turn switch "on". Let heat for 4-5 minutes. Practice on scrap of paper before beginning project.
2. Using the 1 1/4"x4" heavy cardstock, write THANK on one card and YOU on the other using the Hot Stamps Alphabet. Leave room on the left side for overlapping and button. After using each letter, turn Tool "off", let cool, insert next letter and turn Tool "on" to heat. When finished, turn switch "off" to cool.
3. Attach Shading Point to Creative HotMarks. Tighten with pliers. Turn switch "on" and allow to heat.Tear edges of two small pictures. Shade edges using Shading Point. Shade edges of 4 1/2"x5 1/2" paper. Turn tool "off" and let cool.
4. Fold 7"x10" in half. Refer to photo for placement. Center 4 1/2"x5 1/2" decorative paper onto 5 1/2"x7" paper. Attach using glue stick. Glue onto front of folded paper. Use glue stick to attach small pictures. Use glue stick to attach THANK YOU tags. Thread string through button. Use craft glue to attach button to tag
Note: Before you begin, the Creative HotMarks™ tool works best when used with the Walnut Hollow™ Tempered Glass Mat.
It will ensure that your work area will not be damaged from heat. Use masking tape to secure the Pen holder to the work surface.
Attach and tighten with pliers the Point you are going to use on the Creative HotMarks™. Plug Pen in and turn switch "on".
It usually takes 3-4 minutes for the Pen to heat. Remember when changing Points, they are hot and need pliers to remove or attach to the Creative HotMarks™.
After removing the hot Points, place them in the molded tray of the Tempered Glass Mat to cool.
|
