|
Instructions:
1. Attach Transfer Point to Creative HotMarks™ and tighten using pliers. Plug into electrical outlet, and turn switch to "on". Allow to heat for 4-5 minutes.
2. Transfer designs by placing laser copy, print side down onto paper, apply pressure, moving quickly in a circular motion, until image is transferred. Transfer 15 leaves onto Tan Paper, 3 leaves onto White Paper, 3 pumpkins onto White Paper, and "FALL FUN" to shipping tags. Turn pen "off" and allow to cool.
3. Attach Shading Point and tighten with pliers. Turn Creative HotMarks™ "on". Prepare Tan paper by tearing all edges. Burn torn edges with Shading Point. Turn pen "off" and allow to cool.
4. To add color to transferred designs, use Oil Color Pencils. Use glue stick to adhere Tan paper to Brown/Gold Leaf paper.
5. Attach Hot Knife to Pen and tighten with pliers. Turn Creative HotMarks™ "on". To cut foam core board into frames, measure and mark 1/2" from edges of foam core board, place on hard surface, use metal ruler to cut all sides. Cut several tiny scraps of foam core board (approximately 1/2"x 1/2") for later use. Turn pen "off" and allow to cool.
6. To add texture, apply Mod Podge to foam core board frames. Crinkle tissue paper and apply to wet Mod Podge. Let dry. Apply second coat if needed.
7. Adhere photos to Tan paper with glue stick. Glue frame over photo.
8.Tie leather lace to FALL FUN tags. Add color to tags with gold stamp pad and Oil Color Pencils. To add dimension to FALL FUN tags, extra leaves and pumpkins, use scraps of foam core board. Glue to back and adhere to page.
9. Adhere pumpkin charm with craft glue.
10. Tie a bundle of raffia to resemble corn stalk. Use craft glue to attach to right side of page. Place pumpkins around bottom of corn stalk.
11. Cut out pumpkin photos and adhere to shipping tags.
12. To prepare Memory Frame for staining, lightly sand with fine sandpaper and remove dust with tack cloth or paper towel. Use foam brush to apply stain to wood. Follow directions on container. Remove excess stain with paper towel. Let dry.
13. Apply 2-3 coats of spray varnish. Let dry between coats. Secure scrapbook page
to Memory Frame with small Velcro Dots.
Note: Before you begin, the Creative HotMarks™ tool works best when used with the Walnut Hollow™ Tempered Glass Mat.
It will ensure that your work area will not be damaged from heat. Use masking tape to secure the Pen holder to the work surface.
Attach and tighten with pliers the Point you are going to use on the Creative HotMarks™. Plug Pen in and turn switch "on".
It usually takes 3-4 minutes for the Pen to heat. Remember when changing Points, they are hot and need pliers to remove or attach to the Creative HotMarks™.
After removing the hot Points, place them in the molded tray of the Tempered Glass Mat to cool.
|
