|
Instructions:
1. Follow basic set up instructions for the Creative Hot Marks™. Attach the letter "B" from the Creative HotStamps™ Alphabet Set to the Pen. Plug in, turn switch "on" and allow to heat.
2. Cut 1.5" from the bottom of 1 Paper Maché Tag to create a 2.5" x 1.5" rectangle. With the Creative HotMarks™, stamp the letter "B" onto the paper maché rectangle. Turn switch "off" and allow Creative HotMarks™ to cool.
3. When Creative HotMarks™ is cool, attach the letter "O" from the Creative HotStamp™ Alphabet Set to the Pen. Turn switch "on" and allow to heat.
4. Complete the word "BOO" by stamping the "O" twice on the paper maché rectangle. Turn switch "off" and allow Creative HotMarks™ to cool.
5. When Creative HotMarks™ is cool, attach the pumpkin stamp from the Creative HotStamp™ Everyday Set to the Pen. Turn switch "on" and allow to heat.
6. On the small wooden tag, stamp the pumpkin twice on each side - refer to finished product photo for placement.
7. Cut a 11" x 5" rectangle out of the black cardstock. Fold in half, vertically to create your card.
8. Cut a 4.5" x 4" rectangle out of orange cardstock. Adhere to front of the card using adhesive.
9. Using a decorative edge scissors, cut a 3 1/4" x 2 3/4" rectangle out of black cardstock. Adhere to center of orange cardstock on card.
10. Using an eyelet setter, set and attach two eyelets in upper corners of the decorative edge black cardstock.
11. Using adhesive, attach paper maché rectangle to the center of your card.
12. Tie black ribbon around the fold of your card in a knot. Be sure to leave excess ribbon at the end of the knot; about 1.5" for each end.
13. On one ribbon end, tie on the wooden tag. On the other, tie the Jolee's By You® Trick or Treat Bag.
Note: Before you begin, the Creative HotMarks™ tool works best when used with the Walnut Hollow® Tempered Glass Mat. It will ensure that your work area will not be damaged from heat. Use masking tape to secure the Pen holder to the work surface. Attach and tighten with pliers the Point you are going to use on the Creative HotMarks™. Plug Pen in and turn switch "on". It usually takes 3-4 minutes for the Pen to heat. Remember when changing Points, they are hot and need pliers to remove or attach to the Creative HotMarks™. After removing the hot Points, place them in the molded tray of the Tempered Glass Mat to cool.
|
