Memory Frame Clock
Designed by Erin Bykowski for Walnut Hollow

Materials:
-Walnut Hollow® Designed for Her™ Creative Drill™ #26443
-Walnut Hollow® Designed for Her™ Creative Jewel Tool™ #27690
-Walnut Hollow® Memory Frame, Lg #25392
-Walnut Hollow® Clock Movement TQ500P
-Paint
-12”x12” Scrapbook Paper
-Scrapbook flower embellishments
-Adhesive backed crystals
-Flat head and decorative tacks
AA Battery, drill with 3/8” drill bit, flat brush, paper glue, paper towel, pliers, sandpaper, spray varnish, tape, wood filler

Instructions:

1. To prepare Memory Frame for paint, fill all nail holes. Use sandpaper to lightly sand entire wood surface. Remove dust with paper towel or tack cloth. Use flat brush to apply paint to entire surface. Let dry. Apply second coat if necessary. Let dry. Apply 2-3 coats of spray varnish.
2. Use paper glue to adhere 12”x12” paper inside Memory Frame.   
3. Refer to photo for placement. Use Creative Drill™ to drill holes for attaching tacks into edge of frame.  Match the size of the bit to the tack. Use hammer to attach tacks.  
4. Locate center of frame. Use drill with 3/8” drill bit to create hole for clock movement. Drill through center from front to back. Attach Clock Movement. Follow directions on packaging.
5. Use scrapbook flower stickers to represent clock hours. 
6. Attach Flow Point to the Creative Jewel Tool™. Tighten with pliers. Secure stand to hard surface with tape. Place tool on stand. Plug into electric outlet. Turn switch “On”. Let heat for 4-5 minutes. Adhere adhesive backed crystals between tacks. Use tweezers to place crystal in position. Hold tool perpendicular to crystal. Lightly touch center of crystal and hold for approximately 15 seconds. The heat will melt the adhesive on the back. Also, add crystals to the center of 12, 3, 6, and 9, flower stickers. Crystals could also be added to the clock hands before attaching to Clock Movement.
7. Insert battery in clock.