Bookmark and Share

You have not viewed any products recently.

 
 

NATURE CLOCK

butterfly-clock

Walnut Hollow® Products:

  • #38383 Creative Versa Tool®
  • #27670 Basswood Country Round®
  • #23855 ¾” 3 Pc. Clock Kit 

Other Supplies:

  • Oil Pencils
  • Color laser image of your choice, approx. 8” x 6”
  • One AA battery
  • Blue painters tape
  • Drill
  • Fine sandpapeR
  • Spray varnish

 

Instructions:

Note: Image needs to be from a laser copy machine for transfer to be successful.

  1. Read all instructions and safety information on packaging.

  2. Drill a 3/8” hole in the center of Basswood Country Round®

  3. Use masking tape to secure the Pen holder to the work surface.  Attach and tighten with pliers the Point you are going to use on the Creative Versa-Tool.  For this project, the Transfer Point will be used.

  4. Plug the cord into the electrical outlet to heat.  It usually takes 3-4 minutes for the Pen to heat.  Remember when changing Points, they are hot, and pliers are needed to attach and remove Points from the Creative Versa-Tool.

  5. Tape laser image face down onto Basswood Country Round® with blue painter’s tape.

  6. Using a circular motion, rub the Transfer Point against the back of the copied image.

  7. It will take approximately 15-20 minutes to transfer the design from the copy to the Basswood Country Round®.

  8. Use Oil Pencils to add color and define image. 

  9. For a protective finish, spray 2-3 coats of varnish

  10. Use fine sandpaper to distress clock numbers. 

  11. Adhere clock numbers to the front of the clock.

  12. Follow package instructions to install clock movement.

  13. Insert AA battery. Set time. Enjoy! 

 

Designed by Rebekah Meier for Walnut Hollow®

 

WALNUT HOLLOW PRODUCTS USED IN THIS PROJECT: