Bookmark and Share

You have not viewed any products recently.

 
 

Gallery Clock

Gallery-Clock

Walnut Hollow® Products:

  • #27636 Gallery Clock
  • #23855 3 Piece Clock Kit

Other Supplies:

  • 1 Sheet of 18”x18” decorative paper
  • 1 8.5 x11 or larger Sheet of coordinating paper – enough to cut twelve 1 3/4” circles
  • Twill Tape to coordinate with paper – 6 strips 16” long
  • AA battery
  • Adhesive spray
  • 1 3/4” circle punch
  • Craft glue
  • Fabric glue
  • Glitter glue
  • Sandpaper
  • Scissors

Instructions:

  1. To prepare wood for adhering paper, use sandpaper to lightly sand wood surface. Remove dust with paper towel.

  2. Lay down the 18”x18” paper on a flat surface. Create a 16 inch circle in the middle of paper.  Use scissors to cut out circle.  Use scissors to cut little slits around the edge of the circle about 1/2” deep.  This is done so that when the paper is wrapped around the back of clock the paper will lay flat.

  3. Apply spray adhesive to the back of the circle.  Lay the clock, top side down, in the middle of the sprayed paper.  Wrap the ends around the back of the clock.  Smooth out any wrinkles.  Let dry.

  4. Remove the paper from the clock movement opening with a scissors.

  5. Use scissors to cut six 16” strips of twill tape.

  6. Use fabric or craft glue to adhere twill tape to paper as shown in photo.  Use scissors to cut away the tape that is covering the clock movement opening as each strip is adhered.

  7. Use a 1 3/4” circle punch to create 12 circles from coordinating decorative paper.  Use spray adhesive to attach circles over twill tape, to designate where the clock numbers will be.

  8. Use small brush to apply glitter glue to clock numbers and clock hands.  Let dry.

  9. Press clock numbers on circles.

  10. Attach clock movement to clock as shown on packaging.

  11. Insert AA battery.

 

Designed by Janet Wilhelm for Walnut Hollow®

 

WALNUT HOLLOW PRODUCTS USED IN THIS PROJECT: